Finished products support table

The support table is composed of a tiltable bracket and a tilting bracket. The total length of the device is 12m.

When the finished product is sent from the main machine to the tiltable bracket, it will be cut off after reaching a certain length. The host machine sends a signal, and the cylinder action makes the tiltable bracket tilt. Under the action of the workpiece's dead weight, the finished product will slide down to the packaging platform automatically through the tilting bracket. Tilting bracket can be automatically returned.

When the finished product workpiece slides from the finished product bracket to the packaging platform, it shall be stacked neatly and stored in a certain number of finished products by the manual, and then the finished products shall be packed and taken away by the manual.

Note: this system needs the air source provided by the customer. The air pressure shall not be less than 0.5mpa. The flow rate shall not be less than 0.5 cubic meters per minute; The air source should be dry and clean.